User Manual

OG_CDP-02E-R-457M_v11e Circuit Design, Inc.
16
OPERATION GUIDE
Regulatory compliance information
CDP-RX-02E-R 457 MHz
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution:
Any changes or modifications not expressly approved by the party responsible for product compliance could
void the user's authority to operate the equipment.
Caution Exposure to radio frequency radiation:
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be
maintained between the antenna of this device and all persons. This device must not be co-located or operating
in conjunction with any other antenna or transmitter.
Labelling:
Circuit Design transmitter module CDP-TX-02E-R 457 MHz labelled as below.
FCC ID: V9X-CDP02ER457
The proposed FCC ID label format is to be placed on the module. If FCC ID is not visible when the module is
installed into the system, "Contains FCC ID: V9X-CDP02ER457" shall be placed on the outside of final host
system.
Circuit Design receiver module CDP-RX-02E-R 457 MHz labelled as below.
FCC ID: V9X-CDP02ER457R
The proposed FCC ID label format is to be placed on the module. If FCC ID is not visible when the module is
installed into the system, "Contains FCC ID: V9X-CDP02ER457R" shall be placed on the outside of final host
system.