User`s guide

Configuration Fields
The following table is a description of the Configuration Fields grouped
into the three sections (Network Settings, Radio Comm Settings and
Channel Mask) of the ZNWizard main window. In the center of the dialog
window is a box labeled “Network Settings”. The first drop down menu is
labeled “Network” as shown below.
Network
This setting selects the type of network of ZN-
241Gs you would like to set up. The three
choices are:
Auto-Config —This is a network with only two
radios (this is called a Point-to-point Network). In
this mode, one of the two radios will
automatically make itself the base radio and the
other will remain a remote. In a point-to-point
network, it doesn’t matter which ZN-241G is the
base and which is the remote.
Point-to-Point — This is also a network with
only two radios. In this mode, rather than having
the radios decide which will be the base and
which will be the remote, you must set one
radio, and only one radio, to be the base. It
doesn’t matter which radio is set to be the base.
This mode is useful when there are multiple
point-to-point networks in the same area to
make sure the right two radios connect.
Multipoint — This is a network with more than
two radios (this is sometimes called a Point-to-
Multipoint Network). In this type of network, one
radio and only one radio must be set to be the
base. All of the data sent to the base is
transmitted to all of the other radios in the
network. Data sent to any remote is always
transmitted to the base radio and only the base
radio. Only a radio configured as a Base can be
set to Multipoint. All Remotes in a Multipoint
network must be set to Point-to-point mode.
10