User`s guide

Attaching the Antenna
The ZN-241GI radio is supplied with a foldable antenna with a screw
type connector. Attach the antenna to the ZN-241GI by threading the
antenna onto the antenna connector on the rear of the ZN-241GI, turning
until finger tight. Fold the antenna at a right angle so the antenna is
sticking up above the ZN-241GI.
If the folding part of the antenna is not in the right position to stick up
above the ZN-241GI, hold onto the knurled bottom of the antenna and
twist the upper part of the antenna until the foldable part of the antenna
sticks up above the ZN-241GI. DO NOT TWIST THE ENTIRE ANTENNA
AS THIS MAY DAMAGE THE ANTENNA.
Using the Data/Power Connector
The Data/Power connector is designed to allow easy installation and
removal of individual wires. All needed wires should be installed in the
connector before plugging the connector into the ZN-241GI. Once
installed, the connector can be removed and reinstalled as needed;
however, do not pull on the wires to remove the connector as this may
cause the connections to fail.
The Data/Power connector can accept individual wires ranging from 26
to 20 gauge in size. To connect a wire, position the connector such that
the holes for the wires are along the top and the small orange levers are
along the bottom. Strip the insulation from the wire to be connected to
expose about ¼” of bare conductor. Locate the orange lever beneath the
hole you want to use for the wire. Using a small screwdriver or nail file,
depress the orange lever and insert the wire into the hole. The wire
should easily slide into the hole. Once the wire is fully inserted, release
the orange lever. This will allow the springs inside the connector to
securely connect the wire.
2