Owner manual
Table Of Contents
- 1. Pin Descriptions
- 2. Characteristics and Specifications
- Recommended Operating Conditions
- Absolute Maximum Ratings
- DAC Analog Characteristics
- Combined Digital and On-Chip Analog Filter Characteristics
- Switching Specifications - Serial Audio Interface
- Digital Interface Characteristics
- Internal Power-On Reset Threshold Voltages
- DC Electrical Characteristics
- 2.1 Digital I/O Pin Characteristics
- 3. Typical Connection Diagram
- 4. Applications
- 5. Combined Digital and On-chip Analog Filter Response Plots
- Figure 10. Single-Speed Stopband Rejection
- Figure 11. Single-Speed Transition Band
- Figure 12. Single-Speed Transition Band (detail)
- Figure 13. Single-Speed Passband Ripple
- Figure 14. Double-Speed Stopband Rejection
- Figure 15. Double-Speed Transition Band
- Figure 16. Double-Speed Transition Band (detail)
- Figure 17. Double-Speed Passband Ripple
- Figure 18. Quad-Speed Stopband Rejection
- Figure 19. Quad-Speed Transition Band
- Figure 20. Quad-Speed Transition Band (detail)
- Figure 21. Quad-Speed Passband Ripple
- 6. Parameter Definitions
- 7. Package Information
- 8. Ordering Information
- 9. Revision History
DS895F2 15
CS4354
Figure 7. De-Emphasis Curve, Fs = 44.1 kHz
Note: De-emphasis is only available in Single-Speed Mode.
4.5 Internal High-Pass Filter
The CS4354 includes an internal digital high-pass filter. This filter prevents a constant digital offset from cre-
ating a DC voltage on the analog output pins. The filter’s corner frequency is well below the audio band; see
“Combined Digital and On-Chip Analog Filter Characteristics” on page 7 for filter specifications.
4.6 Digital Interface Format
The device accepts audio samples in the industry standard I²S format only.
For an illustration of the required relationship between the LRCK, SCLK and SDIN, see Figure 6 on page
14. SDIN is valid on the rising edge of SCLK. For more information about serial audio formats, refer to Cirrus
Logic Application Note AN282: The 2-Channel Serial Audio Interface: A Tutorial, available at
http://www.cirrus.com.
4.7 Internal Power-On Reset
The CS4354 features an internal power-on reset (POR) circuit. This circuit monitors the VA supply and au-
tomatically asserts or releases an internal reset of the DAC’s digital circuitry when the supply reaches de-
fined thresholds (see “Internal Power-On Reset Threshold Voltages” on page 10). No external clocks are
required for the POR circuit to function.
Figure 8. Internal Power-On Reset Circuit
Gain
dB
-10dB
0dB
Frequency
T2 = 15 µs
T1=50 µs
F1 F2
3.183 kHz 10.61 kHz
Power-On Reset
Circuit
VA
GND
reset
(internal)