User`s manual
JampII-mini Users Manual - 6 - PD0606-6-00-01
Q JP10 Factory test input
R JP5 Boot mode selection (BOOT 0)
S JP4 Boot mode selection (BOOT 1)
T J14 DB9 RS-232 output
U J10 RS-485 output
V J5 Ethernet port connector
3.1. Assembly and Connections
In order to use JampII-mini, the user must first assemble and connect the peripherals to
JampII-mini, as described in the following procedure.
1. Place JampII-mini on a static free surface.
2. Make sure all of the jumpers are in the default position. See Table3-2 for more on jumper
setting.
3. Connect 5V regulated power supply to the board.
4. Connect serial cross cable between JampII-mini UART 1 (J13) and PC/terminal serial port.
5. Launch a terminal program such as HyperTerminal on the PC. Configure the serial port with the
following parameters: 57600 bits per second, 8 data bits, no parity, 1 stop bit, no flow control.
6. Connect the board to a local area network (optional). User can connect JampII-mini directly to
one computer with cross cable, or use ordinary Ethernet cable connects JampII-mini to hub.
3.2. Operation
When power is first apply all LED in JampII-mini will light up, after a short period the red LED
will turn off. If the red LED turns on for a very long period after power up, it is possible that hardware
may already damage. In this case, please contact Design Gateways tech support (support@design-
gateway.com).
A few second after red LED turn off, the debug information will be displayed on the terminal
program. For more detail about software functionality, please see Chapter 5 Software Description
3.3. Configurations
Jumpers are used to configure JampII-mini to operate in different mode. The following table
lists all the settings for each jumper.