Operating instructions

CMax Selection Page
600-00108-000 Rev 07 -60- Entegra EX5000
2) AutoFill—When pressed, moves the detected destination airport
listed on the button into the Airport Entry Field.
3) Select Chart—Moves the active selection cursor from the Airport
Entry Field to the Chart Selection list.
4) Next Letter—Use Next Letter to move the cursor within the
Airport Entry Field to the next character location.
5) Select Knob—Use the right knob to select the character for the
current cursor position when entering an airport identifier.
Note: The AutoFill button automatically detects the destination
airport if the final waypoint is an airport or a waypoint that is part of
an instrument approach procedure. However, for some
approaches, AutoFill may detect another nearby airport rather than
the intended destination. Make sure the desired airport is
displayed before pressing the button. AutoFill does not display
under the following conditions:
• An Airport cannot be determined due to GPS limitations.
• When the feature is not supported by some GPS models.
• The current airport destination is not available in your chart data
coverage area.