User's Manual

13. The WEP Passphrase (Figure 9-13) value allows the user to change the
passphrase that is used to generate the encryption key for WEP. Any
alphanumeric value can be entered here, but it will only be activated if you
choose either 64 or 128 bit under Encryption. This value can also be
changed using the Configuration Utility. For further information, see
Chapter 7: Configuration Utility.
Once your card is configured, click the OK button to finish setting the
Advanced Options.
Network PC Card
11. The value for SSID
(Figure 9-11) depends
on what Network
Type was selected.
Infrastructure net-
works should have the
same SSID as the
Access Point. All
clients in an Ad-Hoc
Network should share
the same SSID. Click
Transmit Rate to
continue or the OK
button to finish set-
ting the Advanced
Options.
12. The Transmit Rate
affects the speed of
transmission to anoth-
er wireless device.
The rate can either be
set to a fixed value or
left at the default value
of Full Auto, as shown
in Figure 9-12, which
lets the computer
determine the best
transfer rate. The first
option, Auto Select 1
or 2, is for compatibil-
ity with older wireless
equipment. Click
WEP Passphrase to
continue or the OK
button to finish setting
the Advanced Options.
Figure 9-13
Figure 9-11
Figure 9-12
Instant Wireless
TM
Series
47 48