User Manual

Chapter 5: Installing the Network
PC Card
1.Locate an available Type II or Type III PCMCIA slot on
your notebook computer.
2. With the Network PC Card’s 68-pin connector facing the PCMCIA slot
and the “Network PC Card” label facing up, as shown in Figure 5-1, slide the
Network PC Card completely into the PCMCIA slot while the computer is
restarting and before the Windows desktop appears.
3. You may see several screens appear as the driver installation is finalized.
This is normal. No input should be necessary, and the screens should dis-
appear when the card is ready for use.
The Hardware Installation is complete. Your Wireless Network PC Card
is set up and ready for use. You may continue reading to learn about the
card’s Configuration Utility in Chapter 6 for Windows NT or Chapter 7
for other Windows Operating Systems.
The Windows XP
compatibility screen
will appear, as
shown in Figure 4-2.
As this card has
been tested to work
with Windows XP,
click the Continue
Anyway button to
continue.
On the final instal-
lation screen, click
the Finish button
to complete instal-
lation.
The Hardware Installation is complete.
Windows XP automatically detects and configures the Network PC Card for
your wireless network. To adjust these settings, refer to your Windows XP doc-
umentation.
15
Figure 4-2
Figure 4-3
Instant Wireless
TM
Series
Network PC Card
16