User's Manual Part 1
Table Of Contents
- contents
- Preface
- Product Overview
- Preparing for Installation
- Installing the Client Adapter
- Using the Profile Manager
- Configuring the Client Adapter
- Overview
- Setting System Parameters
- Setting RF Network Parameters
- Setting Advanced Infrastructure Parameters
- Setting Advanced Ad Hoc Parameters
- Setting Network Security Parameters
- Using EAP Authentication
- Performing Diagnostics
BETA DRAFT - CISCO CONFIDENTIAL
5-29
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-03
Chapter 5 Configuring the Client Adapter
Setting Network Security Parameters
Follow the steps below to enable LEAP authentication for this profile.
Step 1 Select LEAP from the Network Security Type drop-down box on the bottom of the Network Security
screen.
Note When you select this option, dynamic WEP is set automatically.
Note The LEAP option is available only if you selected LEAP during the ACU installation process
and the firmware supports it.
Step 2 Click Configure to the right of the Network Security Type drop-down box. The LEAP Settings screen
appears (see Figure 5-6).
Figure 5-6 LEAP Settings Screen