User's Manual Part 1
Table Of Contents
- contents
- Preface
- Product Overview
- Preparing for Installation
- Installing the Client Adapter
- Using the Profile Manager
- Configuring the Client Adapter
- Overview
- Setting System Parameters
- Setting RF Network Parameters
- Setting Advanced Infrastructure Parameters
- Setting Advanced Ad Hoc Parameters
- Setting Network Security Parameters
- Using EAP Authentication
- Performing Diagnostics
BETA DRAFT - CISCO CONFIDENTIAL
5-33
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-03
Chapter 5 Configuring the Client Adapter
Setting Network Security Parameters
Step 10 Select the Enable network access control using IEEE 802.1X checkbox.
Step 11 Perform one of the following:
• If you are planning to use EAP-TLS, select Smart Card or other Certificate for EAP type; then
go to Step 12.
• If you are planning to use EAP-MD5, select MD5-Challenge for EAP type; then go to Step 16.
Step 12 Click Properties. The Smart Card or other Certificate Properties screen appears (see Figure 5-8).
Figure 5-8 Smart Card or other Certificate Properties Screen
Step 13 Select the Use a certificate on this computer option.
Step 14 Select the Validate server certificate checkbox.
Step 15 Make sure that the name of the certificate authority from which the EAP-TLS certificate was
downloaded appears in the Trusted root certificate authority field.
Step 16 Click OK to save your settings. The configuration is complete.
Note Chapter 6 describes the sequence of events that occurs when a profile that is set for EAP authentication
is selected for use.