User's Manual Part 2

BETA DRAFT - CISCO CONFIDENTIAL
9-11
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-03
Chapter 9 Troubleshooting
Error Messages
Error Message Error Reading filename
Explanation
A problem occurred while the computer was reading the firmware file from the disk.
Recommended Action Re-copy the firmware file to a floppy disk or to your computer’s hard drive and
try to load it again or select a different firmware file and try to load it.
Error Message Error Writing to Flash Memory
Explanation A problem occurred while the firmware was being flashed.
Recommended Action Eject the client adapter and reinsert it. If the client adapter functions properly,
the firmware was flashed successfully. If the client adapter does not function or functions improperly,
your client adapter may need to be returned for service. Refer to the “Technical Assistance Center”
section in the Preface for information on contacting TAC.
Error Message Firmware Incompatible with Hardware
Explanation
The selected firmware file does not work with the client adapter.
Recommended Action Select a different firmware file and try to load it.
Error Message Firmware Upgrade Failed
Explanation
A problem occurred while the firmware was being flashed.
Recommended Action Eject the client adapter and reinsert it. If the client adapter functions properly,
the firmware was flashed successfully. If the client adapter does not function or functions improperly,
your client adapter may need to be returned for service. Refer to the “Technical Assistance Center”
section in the Preface for information on contacting TAC.
Error Message Maximum Power Save Mode Will Be Temporarily Disabled While You Are
Running This Application!
Explanation
The client adapter cannot be run in Max PSP mode while ACU is running.
Recommended Action No user action is required. The client adapter automatically runs in Fast PSP
mode while ACU is running.
Error Message No Wireless LAN Adapters Found
Explanation
A client adapter is not inserted in the computer.
Recommended Action Insert a client adapter if you wish to start wireless communications.