Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
9
Note See the Cisco Aironet 1200 Series Access Point Hardware
Installation Guide for a detailed description of these connections.
You must perform the following procedures in order to make your access
point operational:
1. Attach and adjust the antennas.
2. Connect the access point to your network.
3. Power up the access point.
4. Obtain an IP address.
5. Configure the access point.
Additional Requirements
Before you install the access point, make sure you are using a computer
connected to the same network as the access point, and obtain the following
information:
• The MAC address from the label on the bottom of the access point (such
as 00164625854c)
12KDBQSG.bk Page 9 Friday, June 21, 2002 9:53 AM