Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
10
• The following information from your network system administrator:
–
The case-sensitive wireless service set identifier (SSID) for your
radio network
–
If not connected to a DHCP server, a unique IP address for your
access point (such as 172.17.255.115)
–
If the access point is not on the same subnet as your PC, a default
gateway address and subnet mask
Note Plan to configure the access point before mounting it in a relatively
inaccessible location. Some steps, such as those requiring a serial
cable, are easier to perform if the access point is accessible.
Attaching and Adjusting the Antennas
2.4-GHz Dipole Antennas
Attach the antennas to the Reverse-Polarity Threaded Naval Connector
(RP-TNC) connectors on the back of the access point and tighten hand tight.
12KDBQSG.bk Page 10 Friday, June 21, 2002 9:53 AM