Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
12
Connecting to an Ethernet Network with an Inline
Power Source
Caution Both the Ethernet and console ports use RJ-45 connectors.
Make sure that you connect the cable to the Ethernet port and
not to the console port.
Follow these steps to connect the access point to the Ethernet LAN when you
have an inline power source:
1. Connect the Ethernet cable to the RJ-45 Ethernet connector labeled
Ethernet on the access point. Connect the other end of the cable to one
of the following:
a. A switch with inline power, such as a Cisco Catalyst
3524-PWR-XL.
b. An inline power switch panel, such as a Cisco Catalyst Inline Power
Patch Panel.
c. The end of a Cisco Aironet power injector labeled To AP/Bridge and
the other end labeled To Networ k to the 10/100 Ethernet LAN.
12KDBQSG.bk Page 12 Friday, June 21, 2002 9:53 AM