Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
13
Connecting to an Ethernet Network with Local
Power
Caution Both the Ethernet and console ports use RJ-45 connectors.
Make sure that you connect the Ethernet cable to the Ethernet
port and not to the console port.
Follow these steps to connect the access point to an Ethernet LAN when you
have a local power source:
1. Connect the Ethernet cable to the RJ-45 Ethernet connector labeled
Ethernet on the access point.
2. Connect the power pack’s power output connector to the 48-VDC power
port labeled 48VDC on the access point.
3. Plug the other end of the power pack into an approved 100 to 250 VAC
outlet.
12KDBQSG.bk Page 13 Friday, June 21, 2002 9:53 AM