Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
17
Note Both the Ethernet and console ports use RJ-45 connectors. Be
careful when connecting the console cable to avoid connecting to the
Ethernet port.
Procedures for using the command-line console can be found in the Cisco
Aironet 1200 Series Access Point Hardware Installation Guide. The guide is
available on Cisco.com.
Configuring the Access Point
After you have determined or assigned the access point’s IP address, you can
open the access point management pages and initially configure the access
point. Follow these steps.
1. Open your Internet browser. You must use Microsoft Internet Explorer
(version 4.0 or later) or Netscape Navigator/ Communicator (version 4.0
or later).
2. Enter the access point’s IP address in the browser address line and press
Enter. Depending on the method used to assign the IP address, either the
Summary Status (Home) screen or the Express Setup screen opens.
a. If the Express Setup screen opens, go to Step 4.
b. If the Summary Status screen opens, go to Step 3.
12KDBQSG.bk Page 17 Friday, June 21, 2002 9:53 AM