Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
25
A mounting hardware kit is provided that contains the hardware and fasteners
necessary to mount the access point. Refer to the following table to identify
the materials you need to mount your access point, then go to the section
containing the specific mounting procedure.
Mounting Method Materials Required In Kit
Horizontal or vertical
surface
Four #8 x 1 in. (25.4 mm) screws
Four wall anchors
3/16 in. (4.7 mm) or 3/32 in.
(2.3 mm) drill bit
Drill
Standard screwdriver
Yes
Yes
No
No
No
Suspended ceiling Two caddy fasteners with studs
Two plastic spacers
Two 1/4–20 Keps nuts with built-in
washers
Standard screwdriver
Appropriate wrench or pliers
Yes
Yes
Yes
No
No
12KDBQSG.bk Page 25 Friday, June 21, 2002 9:53 AM