Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
26
Mounting on a Horizontal or Vertical Surface
Follow these steps to mount the access point on a horizontal or vertical
surface.
1. Use the mounting bracket as a template to mark the locations of the four
mounting holes.
2. Drill one of the following sized holes at the locations you marked:
• 3/16 in. (4.7 mm) if you are using wall anchors
• 1/8 in. (6.3 mm) if you are not using wall anchors
3. Install the anchors into the wall if you are using them. Otherwise, go to
Step 4.
4. Secure the mounting bracket to the surface using the #8 fasteners.
Note On a vertical surface, be sure to mount the bracket with its security
hasp facing down.
5. Attach the access point to the mounting bracket.
Note You can make your installation more secure by mounting it to a stud
or major structural member and using the appropriate fasteners.
12KDBQSG.bk Page 26 Friday, June 21, 2002 9:53 AM