Quick Start Guide
Table Of Contents
- Cisco One-Year Limited Hardware Warranty Terms
- Preface
- Introduction to the Access Point
- Unpacking the Access Point
- Installing the Access Point
- In Case of Difficulty
- Mounting Instructions
- Safety Information
- Compliance Information
FINAL DRAFT - CISCO CONFIDENTIAL
31
Safety Information
The FCC with its action in ET Docket 96-8 has adopted a safety standard for
human exposure to radio frequency (RF) electromagnetic energy emitted by
FCC certified equipment. When used with approved Cisco Aironet antennas,
Cisco Aironet products meet the uncontrolled environmental limits found in
OET-65 and ANSI C95.1, 1991. Proper installation of this radio according to
the instructions found in this manual and the Cisco Aironet 1200 Series
Access Point Hardware Installation Guide will result in user exposure that is
substantially below the FCC recommended limits.
• Do not touch or move antenna(s) while the unit is transmitting or
receiving.
• Do not hold any component containing a radio such that the antenna is
very close to or touching any exposed parts of the body, especially the
face and eyes, while transmitting.
• Do not operate the radio or attempt to transmit data unless the antenna is
connected; otherwise the radio may be damaged.
• Antenna use:
–
High-gain, wall-mount, or mast-mount antennas are designed to be
professionally installed. Cisco recommends that you contact your
professional installer, VAR, or antenna manufacturer to obtain
proper installation requirements.
12KDBQSG.bk Page 31 Friday, June 21, 2002 9:53 AM