User's Manual

Draft Copy - CISCO CONFIDENTIAL
1-10
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-02
Chapter 1 Overview
Access Point Specifications
Access Point Specifications
The access point specifications are listed in Table 1-1.
Table 1-1 Access Point Specifications
Category Access Point with 2.4-GHz Radio Access Point with 5-GHz Radio Module
Size 6.56 in. W x 7.23 in. D x 1.66 in. H
16.67 cm W x 18.36 cm D x 4.22 cm H
With the 5-GHz antenna in the patch position:
6.56 in. W x 8.04 in. D x 2.21 in. H
16.67 cm W x 20.42 cm D x 5.61
Status Indicators Three indicators on the top panel: Ethernet traffic, status, and radio traffic
Connectors Back panel (left to right): reverse-TNC antenna connector; power connector (for plug-in AC power
module); RJ-45 connector for 10/100 BASE-T Ethernet connections; upside down RJ-45 connector
for serial connections; reverse-TNC antenna connector.
Front Panel: Card Bus connector used for the 5-GHz radio module.
Input Voltage 48VDC nominal. Operational up to 60VDC. Voltage higher than 60VDC can damage the unit.
Input Current With 2.4 GHz radio:
125 mA (typical)
With 5-GHz radio:
TBD mA (typical)
With 2.4-GHz and 5-GHz radios
225 mA (typical)
The access point is capable of drawing 380 mA depending upon the current radios and future radios
installed in the unit.
Operating Temperature Access point:
–4 to 131
o
F (–20 to 55
o
C)
1200 series power injector:
32 to 104
o
F (0 to 40
o
C)
Access point:
–4 to 113
o
F (–20 to 45
o
C)
1200 series power injector:
32 to 104
o
F (0 to 40
o
C)
Storage Temperature –40 to 185
o
F (–40 to 85
o
C) –40 to 185
o
F (–40 to 85
o
C)
Weight Without mounting bracket:
1.6 lbs (0.73 kg) with 2.4-GHz radio
module
Without mounting bracket:
1.87 lbs (0.85 kg) with 5-Ghz radio module
1.97 lbs (0.89 kg) with 5-GHz radio module and
2.4-GHz radio
Power Output 100, 50, 30, 20, 5, or 1 mW
(Depending on the regulatory domain in
which the access point is installed)
40 mW (16 dBm)
20 mW (13 dBm)
10 mW (10 dBm)
5 mW (7 dBm)
Note These values are based on the FCC peak
measurement method as defined in
FCC 15.407 (A)(4)
Frequency 2.400 to 2.497 GHz
(Depending on the regulatory domain in
which the access point is installed)
UNII 1—5.15 to 5.25 GH
UNII 2—5.25 to 5.35 GHz
(Depending on the regulatory domain in which the
access point is installed)