User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation
- Basic Configuration
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Console Cable Pinouts
- Glossary
- Index
Draft Copy - CISCO CONFIDENTIAL
5-2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-02
Chapter 5 2.4-GHz Radio Upgrade
Overview
Overview
This section provides instructions for upgrading the access point 2.4-GHz radio. The following
operations summarize the upgrade procedure:
• Remove all cables and power connections from the access point.
• Follow standard Electro Static Discharge procedures.
• Place the access point on an ESD-protected work surface.
• Open the access point’s 2.4-GHz radio access cover.
• For an access point without the 2.4-GHz radio feature, remove the blank spacer card.
• For an access point with the 2.4-GHz radio feature, remove the existing 2.4-GHz card.
• Install the new 2.4-GHz radio card.
• Close the access point 2.4-GHz radio access cover.
Caution Electrostatic discharge (ESD) can damage the Cisco Aironet radio and the internal components of the
access point. It is recommended that the 2.4-GHz radio upgrade procedures be performed by an
ESD-trained service technician at an ESD-protected workstation.
Unpacking the Radio
Each 2.4-GHz radio is shipped with the following items:
• Quick start guide
• A product registration card
• A T-10 tamper-resistant Torx L-wrench
• A 2.4 GHz radio product compliance label
If anything is missing or damaged, contact your Cisco representative for support.