User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation
- Basic Configuration
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Console Cable Pinouts
- Glossary
- Index
Draft Copy - CISCO CONFIDENTIAL
5-6
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-02
Chapter 5 2.4-GHz Radio Upgrade
Removing a 2.4-GHz Radio
Step 2 Remove the 2.4-GHz radio card from the mini-PCI connector by performing the following operations:
a. Push the card-retaining clips (on each side of card) away from the card (see Figure 5-3). When
released, the radio card springs up (see Figure 5-4).
Figure 5-3 Location of Retaining Clips on 2.4-GHz Radio Card
b.
Grasp the radio card only on the edges, being careful not to touch components on the board or the
gold connector pins.
c. Remove the 2.4-GHz card from the mini-PCI connector.
Step 3 Place the removed 2.4GHz radio card into an anti-static bag.
For instructions on installing a new radio card, go to the “Installing a 2.4-GHz Radio” section.
1 Card-retaining clips
MAIN AUX
74253
1 1