User's Manual

Draft Copy - CISCO CONFIDENTIAL
6-2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-02
Chapter 6 5-GHz Radio Module Upgrade
Overview
Overview
This section provides instructions for upgrading the access point 5-GHz radio module. The following
operations summarize the upgrade procedure:
1. Remove all cables and power connections from the access point.
2. Place your access point on a flat surface.
3. For an access point without the 5-GHz radio feature, remove the 5-GHz radio access cover.
4. For an access point with the 5-GHz radio feature, remove the existing 5-GHz radio module.
5. Install the new 5-GHz radio module.
Unpacking the Radio Module
Each 5-GHz radio module is shipped with the following items:
• Quick start guide
• A product registration card
• A T-10 tamper-resistant Torx L-wrench
• A 5-GHz radio product compliance label
If anything is missing or damaged, contact your Cisco representative for support.
Removing the 5-GHz Radio Access Cover
To remove the 5-GHz radio access cover, follow the instructions below:
Step 1 Remove all cables and power connections from the access point.
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.