User's Manual

Draft Copy - CISCO CONFIDENTIAL
B-6
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-02
Appendix B Declarations of Conformity and Regulatory Information
Declaration of Conformity for RF Exposure
Declaration of Conformity for RF Exposure
The radio module has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF Exposure
from radio frequency devices. For antennas AIR-ANT4121 and AIR-ANT1949, the equipment should
be positioned more than 2 m (39.4 in) from your body or nearby persons. All other approved antennas
(2.4 GHz and 5 GHz) should be installed more than 20 cm (7.9 in) from your body or nearby persons.
The access point (with 5 GHz integrated antenna) must be installed to maintain a minimum 30 cm
(11.8 in) co-located separation distance from other FCC approved indoor/outdoor antennas used with the
access point. Any antennas or transmitters not approved by the FCC cannot be co-located with the access
point antennas. The access point’s co-located 2.4 GHz (2.2 dBi) and 5 GHz integrated antennas support
a minimum separation distance of 10 cm (3.9 in) and are compliant with the applicable FCC RF exposure
limit when transmitting simultaneously.
Note Dual antennas used for diversity operation are not considered co-located.
Guidelines for Operating Cisco Aironet Access Points in Japan
This section provides guidelines for avoiding interference when operating Cisco Aironet access points
in Japan. These guidelines are provided in both Japanese and English.
Japanese Translation
03-5549-6500
43768