User's Manual

DRAFT - CISCO CONFIDENTIAL
1-7
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
OL-4072-01
Chapter 1 Overview
Bridge Specifications
Connectors Bottom panel (left to right): Ethernet port1 and port 2
(two F-type connectors), RSSI port (male BNC
connector)
Front Panel (external antenna configuration):
antenna Type N connector
Side panel (left to right): 48VDC power
connector, two coaxial uplink F-type
connectors, and Ethernet RJ-45 connector
for 100BASE-T Ethernet
Operating Temperature –22 to 131
o
F (–30 to 55
o
C) 32 to 122
o
F (0 to 50
o
C)
Cold Start Temperature -22
o
F (-30
o
C) na
Warm-up time
(for full performance)
15 minutes after cold start na
Non-Operational
Temperature
–40 to 185
o
F (–40 to 85
o
C) -40 to 158
o
F (-40 to 70
o
C)
Operational Altitude 6,562 ft (2000 m) 6,562 ft (2000 m)
Non-Operational
Altitude
16,000 ft (4877 m) 16,000 ft (4877 m)
Humidity 0 to 100% (condensing) 0 to 90% (non-condensing)
Operational Vibration 0.001 G
2
/Hz from 5-100 Hz 0.001 G
2
/Hz from 5-100 Hz
Non-Operational
Vibration
0.01 G
2
/Hz from 5-100 Hz 0.01 G
2
/Hz from 5-100 Hz
Environmental Testing
Compliance
Integrated antenna configuration:
The enclosure has been successfully tested for
protection against the ingress of particulate
matter and fluids in compliance with a NEMA
Type 4 (IP56) enclosure rating.
External antenna configuration:
The enclosure has been successfully tested and is
in compliance with a NEMA Type 4 (IP56)
enclosure rating.
na
Weight Integrated antenna configuration:
11 lbs (4.99 kg)
External antenna configuration:
10 lbs (4.54 kg)
Power injector—1.4 lbs (0.6 Kg)
Power Module—TBD
Input Voltage 48 VDC nominal (supplied by Ethernet dual-coax
cables)
Power injector—48 VDC nominal
Power module—100-240 VAC
Power Consumption 41 W (typical)
TBD W (maximum)
TBD W (maximum)
Transmit Power 24, 23, 22, 21, 18, 15, 12 dBm na
Frequency UNII 3—5.725 to 5.825 GHz
(Depending on the regulatory domain)
na
Wireless modulation Coded Orthogonal Frequency Division Multiplexing
(COFDM)
na
Table 1-1 Bridge, Power Injector, and Power Module Specifications (continued)
Category Bridge Power Injector