User's Manual
Table Of Contents
- Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
- Preface
- Overview
- Installation Overview
- Mounting and Alignment Overview
- Configuring the Bridge for the First Time
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Channels and Antenna Settings
- Glossary
- Index
DRAFT - CISCO CONFIDENTIAL
2-8
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
OL-4072-01
Chapter 2 Installation Overview
Installation Summary
Figure 2-4 Power Module
Figure 2-5 Grounding Block
Installation Summary
During the installation of the bridge, you will perform the following operations:
• Connect a user supplied CAT5 Ethernet cable from your wired LAN network to the power injector.
• Connect the dual-coax Ethernet cables between the power injector and the grounding block
Tip You can connect the dual coax cable connectors to either of the grounding block connectors or
the power injector’s Ethernet ports. The bridge senses the Ethernet signals and automatically
switches internal circuitry to match the cable connections.
• Connect a ground wire to the grounding block.
• Mount the bridge to the external tower or mast. For additional information, refer to the Cisco Aironet
Series 1400 Wireless Bridge Mounting Instructions that shipped with your bridge.
• Connect a ground wire to the bridge (use the bridge ground lug)
1 48 VDC power output cable 2 Power module
3 AC power cord
1
2
3
88829
1 and 2 F-type coaxial connectors 3 Ground wire lug
88830
1 2 3