Installation Manual

First Draft - CISCO CONFIDENTIAL
7-7
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 7 2.4 GHz Radio Upgrade
Installing a 2.4-GHz Radio
Step 7 Insert the antenna card into the notch in the support bracket and gently push until it is seated (see
Figure 7-5).
Figure 7-5 Inserting Antenna Card
Step 8
Align the hole on the top of the antenna board with the support post and gently push down until the board
is fully seated on the support post.
Step 9 Carefully position the antenna wires so that the metal connectors do not touch each other.
Caution Damage to the radio could occur if the antenna connectors are touching when power is applied. If they
are touching, carefully rotate them in opposite directions until they are separated.
Go to the Replacing the Back Cover, page 7-8 section.
1 Antenna card 2 Support bracket notch