User's Manual
Table Of Contents
- Cisco Aironet 1100 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Audience
- Purpose
- Organization
- Conventions
- Related Publications
- Obtaining Documentation
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4 GHz Radio Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
6-6
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 6 Mounting Instructions
Using the Security Hasp Adapter
Using the Security Hasp Adapter
The security hasp on the wall or ceiling mounting bracket and the security hasp adapter locks the access
point to the bracket to make it more secure. After you have installed the access point on the detachable
mounting bracket, follow these steps to secure it with a padlock (Master Lock model 120T, 121T or
equivalent).
Step 1 Connect the Ethernet cable and power jack.
Step 2 Insert the T-shaped tab on the security hasp adapter into the Kensington lock slot on the access point.
See Figure 6-4.
Figure 6-4 Security Hasp Adapter
Step 3
Rotate the adapter to engage it with the security hasp. The hole in the adapter should be aligned with the
hole in the security hasp.
Step 4 Secure the adapter to the security hasp with a padlock. Your installation will look similar to Figure 6-5.
Figure 6-5 Security Hasp with Padlock
8117781176