User's Manual
Table Of Contents
- Cisco Aironet 1100 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Audience
- Purpose
- Organization
- Conventions
- Related Publications
- Obtaining Documentation
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4 GHz Radio Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
7-3
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 7 2.4 GHz Radio Upgrade
Removing the Back Cover
Removing the Back Cover
To remove the access point’s back cover, follow these steps:
Step 1 Remove all cables and power connections from the access point.
Step 2 Remove all static-generating items from the work area, such as plastic material, styrofoam cups, and
other similar items.
Step 3 Place the access point and the new 2.4-GHz radio (in its antistatic bag) on an antistatic work surface.
Step 4 Discharge any static buildup on your body by touching a grounded surface (antistatic work surface)
before proceeding.
Step 5 Position the access point so that the back cover is facing up.
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Step 6 Remove the back cover retaining screw using a philips screwdriver (see Figure 7-1).
Figure 7-1 Access Point Back Cover Screw
Step 7 Hold the front cover with one hand and with the other hand gently slide the back cover towards the
connector end of the unit.
Step 8 Gently lift the connector end of the back cover and remove the cover.
Go to the “Removing a 2.4-GHz Radio” section.
1 Back cover screw 2 Back cover