User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
6-4
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-02
Chapter 6 Mounting Instructions
Mounting Below a Suspended Ceiling
Mounting Below a Suspended Ceiling
Note To comply with NEC code, a #10-24 grounding lug is provided on the mounting bracket.
You should review Figure 6-2 before beginning the mounting process.
Figure 6-2 Mounting Bracket Parts
Follow these steps to mount your access point on a suspended ceiling:
Step 1 Decide where you want to mount the access point.
Step 2 Attach two caddy fasteners to the suspended ceiling T-rail.
Step 3 Use the mounting bracket to adjust the distance between the caddy fasteners so that they align with the
holes in the mounting bracket.
Step 4 Use a standard screwdriver to tighten the caddy fastener studs in place on the suspended ceiling T-rail.
Do not overtighten.
Step 5 Install a plastic spacer on each caddy fastener stud. The spacer’s legs should contact the suspended
ceiling T-rail.
Step 6 Attach the mounting bracket to the caddy fastener studs and start a Keps nut on each stud.
1 Suspended ceiling T-rail 4 Mounting bracket
2 Caddy fastener 5 Keps nut (contains an attached lock washer)
3 Plastic spacer
1
2
2
3
5
3
4
5
74121