Manualshelf

User's Manual

ManualsBrandsCisco Systems ManualsComputers & Accessories802.11a/g PCI adapter
41424344454647484950
10-14
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-05
Chapter 10 Troubleshooting
Error Messages
Error Message Cannot load oemres.dll.
Explanation The oemres.dll file cannot be installed.
Recommended Action Uninstall the current client adapter software; then install the latest release.
Error Message Cisco Aironet 802.11a/b/g wireless adapter software update can’t
proceed. Please insert the adapter in the system and try again.
Explanation
You attempted to upgrade your client adapter’s software when the adapter was not
inserted into your computer.
Recommended Action Click OK, insert your client adapter, and start the upgrade process again.
Error Message DHCP failure.
Explanation
The domain logon failed because of a DHCP failure.
Recommended Action Try again to authenticate. If this message reappears, contact your system
administrator.
Error Message During installation, you chose not to use Microsoft Wireless
Configuration Manager to control your Cisco Aironet Wireless LAN Client Adapter.
However, it is currently enabled for this device. Do you want to disable it?
Explanation
The Microsoft Wireless Configuration Manager is enabled and can be used to control
your client adapter.
Recommended Action If you want to switch control from the Microsoft Wireless Configuration
Manager to ADU, click Ye s . Otherwise, click No.
Error Message Entry must be
xx
characters long. Please enter
xx
more characters.
Explanation The static WEP key that you entered on the Define Pre-Shared Keys window does not
contain the correct number of characters.
Recommended Action Re-enter the static WEP key following the guidelines in the “Enabling Static
WEP” section on page 5-26.
Error Message Error importing the EAP-FAST PAC file.
Explanation
An error occurred while a PAC file was being imported. The operation was not
completed.
Recommended Action Try again to import the PAC file. If the same message appears, obtain a new
PAC file from your system administrator and import it.