User's Manual

10-21
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-05
Chapter 10 Troubleshooting
Error Messages
Error Message WEP Key x must be y characters long. Please enter z more characters.
Explanation You entered an incomplete static WEP key on the Define Pre-Shared Keys window and
clicked OK.
Recommended Action Re-enter the static WEP key, making sure to enter the correct number of
characters and click OK.
Error Message ‘ x ’ is not a hexadecimal character.
Explanation The character you entered on the Define Pre-Shared Keys window is not a hexadecimal
character.
Recommended Action Re-enter the static WEP key following the guidelines in the “Enabling Static
WEP” section on page 5-26.
Error Message You are not registered with the authentication server. A security
credential is required to register this device. Do you want to obtain a security
credential?
Explanation
Automatic PAC provisioning is enabled for this profile. However, a valid PAC matching
the server to which the client adapter is connecting could not be found.
Recommended Action Click Yes to provision a new PAC for this server using your existing credentials
or click No to cancel the operation. If you click No, the client adapter is unable to authenticate using
the existing profile.
Error Message You can have only one SSID in an Ad Hoc Network. The SSID selections
on the General Page will be adjusted.
Explanation You chose the Ad Hoc option on the Profile Editor (Advanced) window when multiple
SSIDs were specified on the Profile Editor (General) window.
Recommended Action Click OK. Only SSID1 now appears on the Profile Editor (General) window.
If you want to specify multiple SSIDs, choose Infrastructure for the Network Type parameter on
the Profile Editor (Advanced) window.
Error Message You can have only one SSID in a WPA Passphrase network. The other SSIDs
on the General tab will be disabled. Do you want to continue?
Explanation
You chose the WPA/WPA2 Passphrase security option on the Profile Management
(Security) window when multiple SSIDs were specified on the Profile Management (General)
window.
Recommended Action Click Yes to allow SSID2 and SSID3 to be disabled for this profile or click No
to cancel the operation.