User's Manual
Table Of Contents
- Cisco Aironet 1300 Series Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting and Alignment Overview
- Stacking Bridges
- Configuring the Bridge for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Statement 84—Warning Definition
- Statement 245B—Explosive Device Proximity Warning
- Statement 332—Antenna Installation Warning
- Statement 1001—Work During Lightning Activity
- Statement 1004—Installation Instructions
- Statement 1005—Circuit Breaker
- Statement 1024—Ground Conductor
- Statement 1040—Product Disposal
- Statement 1052—Installing and Grounding the Antenna
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Bridges in Taiwan
- Bridge Specifications
- Channels and Antenna Settings
- Glossary
- Index
CISCO CONFIDENTIAL - First Draft
D-4
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Appendix D Channels and Antenna Settings
Maximum Power Levels and Antenna Gains
Changing the Bridge’s Output Power
This section provides instructions for changing the bridge output power to comply with the maximum
power limits imposed by regulatory domains (see “Maximum Power Levels and Antenna Gains” section
on page D-3). Follow these instructions to change the bridge output power settings using your browser:
Note Administrator privileges may be required to change bridge settings.
Note To meet regulatory restrictions, the external antenna BR1300 configuration and the external antenna
must be professionally installed. The network administration or other IT professional responsible for
installing and configuring the unit is a suitable professional installer. Following installation, access to the
unit should be password protected by the network administrator to maintain regulatory compliance.
Step 1 Open your Internet browser.
Step 2 Enter the bridge’s IP address in the browser address or location line and press Enter. An Enter Network
Password screen appears.
Step 3 Enter your username (default Cisco) in the User Name field.
Step 4 Enter the bridge password (default Cisco) in the Password field and press Enter. The Summary Status
page appears.
Step 5 Click Network Interfaces and the network interface menu appears.
Step 6 Click Radio0-802.11G and the 802.11G Status screen appears.
Step 7 Click the Settings tab and the settings screen appears.
Step 8 On the CCK Transmit Power (mW) setting, select the maximum CCK power allowed for your antenna
in your regulatory region.
Step 9 On the OFDM Transmit Power (mW) setting, select the maximum OFDM power allowed for your
antenna in your regulatory region.
Step 10 Click Apply.
Step 11 Close your browser.
For additional configuration information, refer to the Cisco IOS Software Configuration Guide for Cisco
Aironet Bridges.