User's Manual
Table Of Contents
- Cisco Aironet 1300 Series Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting and Alignment Overview
- Stacking Bridges
- Configuring the Bridge for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Statement 84—Warning Definition
- Statement 245B—Explosive Device Proximity Warning
- Statement 332—Antenna Installation Warning
- Statement 1001—Work During Lightning Activity
- Statement 1004—Installation Instructions
- Statement 1005—Circuit Breaker
- Statement 1024—Ground Conductor
- Statement 1040—Product Disposal
- Statement 1052—Installing and Grounding the Antenna
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Bridges in Taiwan
- Bridge Specifications
- Channels and Antenna Settings
- Glossary
- Index
CISCO CONFIDENTIAL - First Draft
Glossary
GL-4
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
multipath
The echoes created as a radio signal bounces off of physical objects.
multicast packet
A single data message (packet) sent to multiple addresses.
N
non-root bridge
A wireless transceiver connected to a remote Ethernet network that communicates only with another
wireless transceiver connected to the main Ethernet network.
O
omni-directional
This typically refers to a primarily circular antenna radiation pattern.
orthogonal Frequency
Division Multiplex
(OFDM)
A modulation technique used by IEEE 802.11a-compliant and IEEE 802.11g-compliant wireless
LANs for transmission at 6, 9, 12, 18, 24, 36, 48, and 54 Mbps.
P
packet
A basic message unit for communication across a network. A packet usually includes routing
information, data, and sometimes error detection information.
power injector
A device that supplies DC power to another device over Ethernet communication lines.
Q
Quadruple Phase Shift
Keying
A modulation technique used by IEEE 802.11b-compliant wireless LANs for transmission at 2
Mbps.
R
range
A linear measure of the distance that a transmitter can send a signal.
receiver sensitivity
A measurement of the weakest signal a receiver can receive and still correctly translate it into data.
RF
Radio frequency. A generic term for radio-based technology.
root bridge
A wireless transceiver connected to the main Ethernet network that communicates with other
wireless transceivers connected to remote Ethernet networks.