User's Manual
Table Of Contents
- Cisco Aironet 1300 Series Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting and Alignment Overview
- Stacking Bridges
- Configuring the Bridge for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Statement 84—Warning Definition
- Statement 245B—Explosive Device Proximity Warning
- Statement 332—Antenna Installation Warning
- Statement 1001—Work During Lightning Activity
- Statement 1004—Installation Instructions
- Statement 1005—Circuit Breaker
- Statement 1024—Ground Conductor
- Statement 1040—Product Disposal
- Statement 1052—Installing and Grounding the Antenna
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Bridges in Taiwan
- Bridge Specifications
- Channels and Antenna Settings
- Glossary
- Index
CISCO CONFIDENTIAL - First Draft
Contents
iv
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
CHAPTER
2 Installation Overview 2-1
Warnings 2-2
Safety Information 2-3
FCC Safety Compliance Statement 2-3
Safety Precautions 2-3
Typical Bridge Installation Components 2-4
Installation Guidelines 2-5
Site Surveys 2-5
Unpacking the Bridge 2-5
Package Contents 2-6
Before Beginning the Installation 2-6
Installation Summary 2-8
CHAPTER
3 Mounting and Alignment Overview 3-1
Mounting the Bridge 3-2
Mounting Hardware 3-2
Multi-function Mount 3-2
Bridge Bracket 3-3
Mast Bracket 3-3
Bridge LEDs 3-3
Aligning the Antenna Using RSSI LED Indications 3-5
CHAPTER
4 Stacking Bridges 4-1
Overview 4-2
Choosing a Second Mounting Location 4-2
Installing the Stacked Bridges 4-2
Verifying Isolation - TBD 4-3
CHAPTER
5 Configuring the Bridge for the First Time 5-1
Before You Start 5-2
Resetting the Bridge to Default Settings 5-2
Obtaining and Assigning an IP Address 5-3
Connecting to the Bridge Locally 5-3
Assigning Basic Settings 5-4
Default Settings on the Express Setup Page 5-8