User's Manual
Table Of Contents
- Cisco Aironet 1300 Series Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting and Alignment Overview
- Stacking Bridges
- Configuring the Bridge for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Statement 84—Warning Definition
- Statement 245B—Explosive Device Proximity Warning
- Statement 332—Antenna Installation Warning
- Statement 1001—Work During Lightning Activity
- Statement 1004—Installation Instructions
- Statement 1005—Circuit Breaker
- Statement 1024—Ground Conductor
- Statement 1040—Product Disposal
- Statement 1052—Installing and Grounding the Antenna
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Bridges in Taiwan
- Bridge Specifications
- Channels and Antenna Settings
- Glossary
- Index
CHAPTER
CISCO CONFIDENTIAL - First Draft
5-1
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
5
Configuring the Bridge for the First Time
This chapter describes how to configure basic settings on your bridge for the first time. The contents of
this chapter are similar to the instructions in the quick start guide that shipped with your bridge. You can
configure all the settings described in this chapter using the command-line interface (CLI), but it might
be simplest to browse to the bridge’s web-browser interface to complete the initial configuration and then
use the CLI to enter additional settings for a more detailed configuration.
This chapter contains these sections:
• Before You Start, page 5-2
• Obtaining and Assigning an IP Address, page 5-3
• Connecting to the Bridge Locally, page 5-3
• Assigning Basic Settings, page 5-4
• What To Do Next, page 5-9
• Using the IP Setup Utility, page 5-9
• Assigning an IP Address Using the CLI, page 5-13
• Using a Telnet Session to Access the CLI, page 5-13