User's Manual
Table Of Contents
- Cisco Aironet 1300 Series Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting and Alignment Overview
- Stacking Bridges
- Configuring the Bridge for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Statement 84—Warning Definition
- Statement 245B—Explosive Device Proximity Warning
- Statement 332—Antenna Installation Warning
- Statement 1001—Work During Lightning Activity
- Statement 1004—Installation Instructions
- Statement 1005—Circuit Breaker
- Statement 1024—Ground Conductor
- Statement 1040—Product Disposal
- Statement 1052—Installing and Grounding the Antenna
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Bridges in Taiwan
- Bridge Specifications
- Channels and Antenna Settings
- Glossary
- Index
CISCO CONFIDENTIAL - First Draft
ix
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Preface
This section describes the objectives, audience, organization, and conventions of the Cisco Aironet 1300
Series Bridge Hardware Installation Guide.
Objectives
This publication explains the steps for initial setup and basic configuration of the Cisco Aironet 1300
Series Wireless Bridge (hereafter called the bridge) supporting 2.4-GHz operation. This publication also
provides troubleshooting information and detailed specifications.
Audience
This publication is for the person installing and configuring a bridge for the first time. The installer
should be familiar with network structures, terms, and concepts.
Organization
This guide contains the following sections:
Chapter 1, “Overview,” describes the major components, features, and specifications of the bridge.
Chapter 2, “Installation Overview,” provides warnings, safety information, and information needed
before you begin the installation of your bridge system.
Chapter 3, “Mounting and Alignment Overview,” provides an overview of components and features used
during bridge mounting and antenna alignment operations.
Chapter 4, “Stacking Bridges,” describes the how to install and verify stacked bridges for increased
bandwidth.
Chapter 5, “Configuring the Bridge for the First Time,” describes how to enter basic bridge
configuration settings.
Chapter 6, “Using the Web-Browser Interface,” describes how to use the web-browser interface to
configure the bridge.
Chapter 7, “Using the Command-Line Interface,” describes how to use the command-line interface
(CLI) to configure the bridge.
Chapter 8, “Troubleshooting,” provides solutions to potential problems encountered during setup.