User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
C-1
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
APPENDIX
C
Access Point Specifications
This appendix provides technical specifications for the Cisco Aironet 1200 Series Access Point.
Table C-1 lists the technical specifications for the access point.
Table C-1 Access Point Specifications
Category Access Point with 802.11b or 802.11g Radio Access Point with 802.11a Radio Module
Size 6.56 in. W x 7.23 in. D x 1.66 in. H
16.67 cm W x 18.36 cm D x 4.22 cm H
With the antenna in the patch position (RM20A and
RM21A):
6.56 in. W x 8.04 in. D x 2.21 in. H
16.67 cm W x 20.42 cm D x 5.61
With the RM22A radio module:
6.56 in. W x 8.76 in. D x 1.66 in. H
16.67 cm W x 22.25 cm D x 4.22 cm H
Status Indicators Three indicators on the top panel: Ethernet traffic, status, and radio traffic.
Connectors Base unit:
Back panel (left to right): reverse-TNC antenna connector; power connector (for plug-in AC
power module); RJ-45 connector for 10BASE-T or 100BASE-T Ethernet connections; upside
down RJ-45 connector for serial connections; reverse-TNC antenna connector.
Front Panel: Card Bus connector used for an 802.11a radio module.
RM22A radio module:
Left and right reverse-TNC antenna connectors
Input Voltage 48 VDC nominal. Operational up to 60 VDC. Voltage higher than 60 VDC can damage the unit.