User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
Contents
iv
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
CHAPTER
2 Installing the Access Point 2-1
Safety Information 2-2
FCC Safety Compliance Statement 2-2
General Safety Guidelines 2-2
Warnings 2-2
Unpacking the Access Point 2-3
Package Contents 2-3
Basic Installation Guidelines 2-3
Installation Above Suspended Ceilings 2-3
Before Beginning the Installation 2-4
Installation Summary 2-5
Connecting the 2.4-GHz Antennas 2-6
Connecting the 5-GHz External Antennas 2-6
Connecting the Ethernet and Power Cables 2-7
Connecting to an Ethernet Network with an Inline Power Source 2-8
Connecting to an Ethernet Network with Local Power 2-8
Powering Up the Access Point 2-9
CHAPTER
3 Configuring the Access Point for the First Time 3-1
Before You Start 3-2
Resetting the Access Point to Default Settings 3-2
Obtaining and Assigning an IP Address 3-3
Connecting to the Access Point Locally 3-3
Assigning Basic Settings 3-4
Default Settings on the Express Setup Page 3-8
Protecting Your Wireless LAN 3-8
Using the IP Setup Utility 3-9
Obtaining and Installing IPSU 3-9
Using IPSU to Find the Access Point’s IP Address 3-10
Using IPSU to Set the Access Point’s IP Address and SSID 3-11
Assigning an IP Address Using the CLI 3-12
Using a Telnet Session to Access the CLI 3-12