User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
6-6
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 6 Mounting Instructions
Mounting Above a Suspended Ceiling
The bracket mounting clip requires the use of an access point mounting bracket (700-13520-03) with
two extra holes (see Figure 6-4).
Figure 6-4 Mounting Bracket Holes
Follow these steps to mount the access point above a suspended ceiling.
Step 1 Insert the bracket mounting clip’s tab into the large hole on the access point mounting bracket.
Step 2 Place the clip over the T-bar box hanger and secure it to the access point mounting bracket (see
Figure 6-5) with the 1/4-20 fastener (supplied with the T-bar hanger).
Figure 6-5 Access Point Mounting Bracket
Note The illustration shows the access point mounting bracket mounted perpendicular to the T-bar box
hanger. You can also mount the bracket parallel to the T-bar box hanger.
Step 3 Determine the location in the ceiling where you will mount the access point and remove an adjacent
ceiling tile.
Step 4 Orient the access point 2-GHz antennas so that they are pointing down when mounted on the T-bar Box
hanger. Orient the 5-GHz antenna for patch or omnidirectional operation as desired.
1 Extra holes
95748
1
1
95739