User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
8-3
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 8 5-GHz Radio Module Upgrade
Removing a 5-GHz Radio Module
Step 3 Remove the 5-GHz access cover using the supplied Torx L-wrench (see Figure 8-1).
Figure 8-1 5-GHz Radio Access Cover
Removing a 5-GHz Radio Module
To remove the 5-GHz radio module, follow these steps:
Step 1 Remove all cables and power connections from the access point.
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 3 Unscrew the two mounting screws using the supplied Torx L-wrench (
Figure 8-2).
Figure 8-2 5-GHz Radio Module
Note Do not attempt to remove the mounting screws from the module; they are captured in the module
housing.
1 Access Cover Screws 2 Access Cover
1 12
74632
1 Mounting screws 3 Access point
2 5-GHz radio module antenna
74631
1 1 2 3