User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 2
8-4
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 8 5-GHz Radio Module Upgrade
Removing a 5-GHz Radio Module
Step 4 Insert your fingers into the base (latch opening) of the 5-GHz radio module (closest to the access point)
and pull straight out from the access point (see Figure 8-3).
Figure 8-3 Removing the 5-GHz Radio Module
Step 5 For a radio module with built-in antenna, fold the antenna down (towards the attached radio card) and
insert the module into a static protected bag.
Step 6 For a radio module with connectors, insert the radio module into a static protected bag.
To install a new 5-GHz radio module, see the
“Installing a 5-GHz Radio Module” section on page 8-5.
74629