User's Manual

Table Of Contents
CISCO CONFIDENTIAL - Draft 2
8-5
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 8 5-GHz Radio Module Upgrade
Installing a 5-GHz Radio Module
Installing a 5-GHz Radio Module
To install a new 5-GHz radio module (RM20A, RM21A, or RM22A) into your access point, follow these
steps:
Step 1 Before you can install a new 5-GHz radio module, you must remove the access cover or an existing
5-GHz radio module (refer to “Removing the 5-GHz Radio Access Cover” or “Removing a 5-GHz Radio
Module”).
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 3 Grasp the new 5-GHz radio module by it’s base (with the latch opening point down or the antenna
pointing up) and insert the card into the access point’s card-bus slot (see
Figure 8-4).
Figure 8-4 Installing a 5-GHz Radio Module (RM20A or RM21A Shown)
Step 4 Push the 5-GHz radio module into the slot until you hear a slight click.
1 Access point 3 Access point card-bus slot
2 5-GHz radio module antenna 4 5-GHz radio card
74604
21
3 4