User's Manual
Table Of Contents
- Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Opening the Access Point Cover
- Mounting the Access Point
- Mounting Above a Suspended Ceiling
- Attaching the Access Point to the Mounting Plate
- Connecting the Ethernet and Power Cables
- Securing the Access Point
- Powering Up the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
CISCO CONFIDENTIAL - Draft 1
2-15
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-01
Chapter 2 Installing the Access Point
Attaching the Access Point to the Mounting Plate
Rotating the Cisco Logo
The Cisco logo on the top of the unit can be rotated to correctly position the logo for any mounting
arrangement, such as when the unit is mounted on a vertical wall, the logo should oriented with the Cisco
Systems positioned on top. The logo should always be oriented to ease reading.
To rotate the Cisco logo, peform these steps:
Step 1 Place the end of an opened paper clip into one of the holes on the logo assembly (see Figure 2-11).
Figure 2-11 Cisco Logo Holes
Step 2
Using the paper clip as a handle, rotate the logo until you reach the desired orientation.
Step 3 Remove the paper clip.
Attaching the Access Point to the Mounting Plate
Follow these steps to attach the access point to the mounting plate:
Step 1 Open the access point cover (see the “Opening the Access Point Cover” section on page 2-8).
Step 2 In the cable bay area, pull the cables through one of the access point cable openings (see Figure 2-6).
1 Cisco logo 2 Status LED
3 Logo assembly holes