Installation Guide
Table Of Contents
- Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Safety Information
- Warnings
- Unpacking the Access Point
- Basic Installation Guidelines
- Before Beginning the Installation
- Installation Summary
- Mounting Overview
- Mounting on a Horizontal or Vertical Surface
- Mounting Below a Suspended Ceiling
- Mounting Above a Suspended Ceiling
- Mounting Access Point on a Desktop or Shelf
- Connecting the Ethernet and Power Cables
- Powering Up the Access Point
- Cable Security Bracket
- Attaching the Access Point to the Mounting Plate
- Securing the Access Point
- Securing the Access Point to the Mounting Plate
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
- Access Point Specifications
- Channels and Power Levels
- Console Cable Pinouts
- Glossary
- Index
Draft 1A - CISCO CONFIDENTIAL
Contents
iv
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
CHAPTER
6 Troubleshooting 6-1
Checking the Access Point LEDs 6-2
Checking Basic Settings 6-4
Default IP Address Behavior 6-4
Enabling the Radio Interfaces 6-5
SSID 6-5
WEP Keys 6-5
Security Settings 6-5
Low Power Condition 6-6
Intelligent Power Management 6-7
Inline Power Status Messages 6-7
Configuring Power Using the CLI 6-9
Issuing the Cisco IOS Command Using the CLI 6-10
Configuring the Access Point System Power Settings Using a Browser 6-11
Running the Carrier Busy Test 6-13
Running the Ping Test 6-14
Resetting to the Default Configuration 6-14
Using the MODE Button 6-15
Using the Web Browser Interface 6-15
Reloading the Access Point Image 6-16
Using the MODE Button 6-16
Web Browser Interface 6-17
Browser HTTP Interface 6-17
Browser TFTP Interface 6-18
Obtaining the Access Point Image File 6-19
Obtaining the TFTP Server Software 6-19
APPENDIX
A Translated Safety Warnings A-1
Statement 245B—Explosive Device Proximity Warning A-2
Statement 332—Antenna Installation Warning A-3
Statement 353—Power Source Warning A-3
Statement 1001—Work During Lightning Activity Warning A-5
Statement 1004—Installation Instructions Warning A-6
Statement 1005—Circuit Breaker (20A) Warning A-7
APPENDIX
B Declarations of Conformity and Regulatory Information B-1
Manufacturers Federal Communication Commission Declaration of Conformity Statement B-2