User's Manual

4/1/05 Adding a Campus Map to the Cisco WCS Database
OL-7426-02
• Click GO to have the Cisco WCS User Interface display the Maps > New Campus page.
• In the Maps > New Campus page, enter the Campus Name and Campus Contact Information,
click Browse to search for and select the Campus graphic name, select Maintain Aspect Ratio (if
desired), and enter the Horizontal Span and the Vertical Span of the map in feet. (Note that the
Campus Horizontal Span and the Vertical Span should be larger than any building or floor plan
to be added to the campus.)
• Click OK to add the Campus Map to the Cisco WCS database. The Cisco WCS User Interface
displays the Maps page.
The Maps page contains a current list of Campus Names, the map type (Campus or Building),
and the current Campus Status (Green for OK, Red for Failure, Amber for Alarm).
• You have added a map to the Cisco WCS database, which corresponds to a single Campus.
• Ensure that the graphic has been added correctly by clicking the new Campus Name to have
the Cisco WCS User Interface display the Maps > <Campus Name> page as shown in the
following figure.