User Manual

CISCO CONFIDENTIAL—DRAFT 1
5-17
Channels and Maximum Power Settings for Cisco Aironet Autonomous Access Points and Bridges
OL-11142-01
Chapter 5 Cisco Aironet 1250 Series Autonomous Access Point
Special Country Restrictions
Special Country Restrictions
Table 5-16 lists special restrictions for wireless operation in some countries.
Changing Autonomous Access Point Output Power
This section provides instructions for changing the 1250 series autonomous access point output power
to comply with the maximum power limits imposed by special regulatory and country restrictions (see
the“2.4 GHz Band (pre-n IEEE 802.11n)” section on page 5-2, the “5 GHz Band (pre-n IEEE 802.11n)”
section on page 5-7, and the “Special Country Restrictions” section on page 5-17).
Note Administrator privileges may be required in order to change access point settings.
Caution To meet regulatory restrictions, the access point and the external antenna must be professionally
installed. The network administration or other IT professional responsible for installing and configuring the
unit is a suitable professional installer. Following configuration, access to the unit should be password
protected by the network administrator to maintain regulatory compliance.
To change the access point output power level, follow these instructions:
Step 1 Use your web-browser to access your access point.
Step 2 When the Summary Status page displays, click Radio0-802.11G or Radio0-802.11A.
Step 3 On the radio status page, click Settings and the radio settings page displays.
Step 4 For the 802.11G radio, follow these steps:
a. Under CCK Transmit Power (dBm), click the desired output power level.
b. Under OFDM Transmit Power (dBm), click the desired output power level.
Step 5 For the 802.11A radio, under Transmit Power (dBm), click the desired output power level.
Step 6 Scroll down to the bottom of the page and click Apply.
Step 7 Close your web-browser.
Table 5-16 Special Country Restrictions for Wireless Operation
Country
Frequency
Bands (GHz)
Regulatory
Domain Special Limitation and Restrictions
South Korea 2.4 and 5 E and –K Maximum antenna gain limited to 6 dBi.
Mexico 2.4 –A End user must limit 2.4 GHz operation to 2450 to 2483.5 MHz and
36 dBm EIRP.
Russian Federation 5 –E End user must limit 5 GHz operation to 5150 to 5350 and 5650 to 5725
MHz.
United States 5 –A Indoor use only from 5150-5250 MHz.