User's Manual

DRAFT - CISCO CONFIDENTIAL

78-18092-01

Resetting to Default Configuration

If you forget your password that allows you to configure the access point, you

may need to completely reset the configuration. You can use the MODE

button on the access point to reset the configuration.

Note These steps reset all configuration settings to factory defaults,

including passwords, WEP keys, the IP address, and the SSID.

Using the MODE Button

Follow these steps to delete the current configuration and return all access

point settings to the factory defaults by using the MODE button:

1. Open the access point cover (refer to the “How to Open the Top Cover”

section on page 2).

2. Disconnect power from the access point (the power jack for external

power or the Ethernet cable for in-line power).

3. Press and hold the MODE button while you reconnect power to the

access point.

4. Continue pressing the MODE button until the Ethernet LED turns

amber. (approximately 2 to 3 seconds). Then release the button.

a521qsg.fmb Page 18 Monday, March 12, 2007 10:40 AM