User Manual

REVIEW DRAFT—CISCO CONFIDENTIAL
2-38
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-12632-03
Chapter 2 Mounting Instructions
Mounting the Access Point
Step 7 Continue with the “Grounding the Access Point” section on page 2-46 and the “Powering the Access
Point” section on page 2-50.
Opening the Access Point Hinged Cover
You need to open the access point hinged cover when you are performing these operations:
• Installing a cable POC Stinger connector
• Installing fiber-optic SFP module and fiber cable take-up reels
To open the access point hinged cover, follow these steps:
Step 1 Use 0.5-in. (13-mm) box-end wrench or socket set to unscrew the six bolts on the front cover of the unit.
Only unscrew the bolts about 2 turns until they are easily turned by hand, do not remove the bolts.
Step 2 The cover is hinged on the bottom. Carefully open the cover and swing it down.
Note If the cover does not swing open easily, carefully loosen the hinge bolts again.