User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
10
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Step 4 After configuring the bridge, remove the Ethernet cable from your PC and connect the power
injector to your wired LAN.
Assigning Basic Settings
After you determine or assign the bridge’s IP address, you can browse to the bridge’s Express Setup
page and perform an initial configuration. Follow these steps:
Step 1 Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later)
or Netscape Navigator (version 4.x).
Step 2 Enter the bridg
e’s IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Step 3 Press Ta
b to bypass the Username field and advance to the Password field.
Step 4 Enter the case-sensitive password Cisco and p
ress Enter. The Summary Status page appears.
Figure 3 shows the Summary Status page.
Figure 3Summary Status Page
Step 5 Click Express Setup. The Express Setup screen appears. Figure 4 shows the Express Setup
page.